Eave membrane
Self-adhering membrane is applied at the eaves and in valleys where ice dams and runoff hit hardest.
Shingle Roofing
Shingle Roof Installation Weehawken, NJ
A new shingle roof in Weehawken is a system of layers, and each one has to go on in the right order for the shingles to do their job, whether the roof is on a new home, an addition or a reroof. One call to (551) 373-3025 reaches a nearby roofer who installs shingle roofs.
Shingles are only the top layer of a shingle roof. Underneath sit the drip edge, an ice and water shield along the eaves and in the valleys, underlayment across the deck and a starter strip that seals the first course. Then come the flashing details and the ventilation, which decide whether the roof stays dry and how long the shingles last.
Shingle choice sets the look, the wind rating and the life of the roof. 3-tab shingles are thin and uniform, and architectural shingles are thicker laminated shingles with a textured, shadowed look and higher wind ratings. For hail-prone areas there are impact-resistant shingles, and lighter colors can help keep a sunny attic cooler.
Shingles are made for sloped roofs. Below a 2 in 12 slope, water moves too slowly for shingles, so low sections get a membrane roof instead. Porches and low additions often need a different material where they tie into the main roof.
Shingle Roof Installation is often paired with shingle roof replacement and roof installation, depending on the cause.
Dealing with this in Weehawken, NJ right now? Call (551) 373-3025 to reach a nearby roofing contractor.
Call nowThe process
Building a shingle roof layer by layer
Here is the order a roofer follows on a new shingle roof.
Prepare the deck
On a reroof or new build, the deck is inspected and fixed first, since shingles follow every dip beneath them. Moisture trapped under underlayment causes buckling later.
Drip edge at the eaves
The eaves get drip edge and a band of ice and water shield, and the valleys get a full-length strip. In cold climates the ice barrier extends past the inside of the exterior wall.
Underlayment rows
Synthetic underlayment or felt is rolled out in overlapping rows from the bottom up, then drip edge goes on along the rakes over it. It is the backup layer if wind ever drives water past the shingles.
Start at the eaves
A starter strip with factory sealant runs along the eaves and rakes so the first course and the edges are glued down. Skipping it is a common cause of edge blow-offs.
Install the field
The field is shingled with correct offsets and nailing, with step flashing, kickout flashing and pipe boots set as the courses reach them. Valleys are finished open with metal or closed-cut, depending on the shingle and the roof.
Cap the roof
Exhaust at the ridge is matched to intake at the soffits so air moves through the attic. Too little intake makes a ridge vent pull air the wrong way.
What is included
Layers of a shingle roof system
Starter strip
Starter shingles and metal drip edge finish the eaves and rakes which keeps wind from peeling up the first course.
Ridge ventilation
Every wall, chimney and pipe gets new flashing, and a ridge vent caps the peak to keep the attic and roof in balance.
Choosing a shingle
3-tab, architectural or impact-resistant shingles are matched to the house so the look and performance both fit.
Synthetic underlayment
A synthetic water barrier goes over every sheet of decking as the second line of defense.
Related service
Architectural Shingle Installation Weehawken, NJ
Architectural shingles go on over the same deck, underlayment and starter as any shingle, with their own nailing pattern. The double thickness only holds if the nails catch both layers, so placement is checked as the roof goes on. Compatible starter and cap products finish the edges and ridge cleanly.
In Weehawken, NJ, architectural shingles are the common choice for both new homes and reroofs. They stand up to wind better than 3-tab, hide small dips in the deck and usually last longer. Look at a few colors on a nearby roof in daylight before deciding.
Related service
Asphalt Shingle Roof Installation Weehawken, NJ
An asphalt shingle roof installation is the most common way to roof a house, and the details decide how well it performs. Problems on new roofs usually trace to high nails, skipped starter or reused flashing. Ask what layers will go down before the shingles and how the valleys will be done.
A new asphalt roof in Weehawken is usually installed in one to three days once the deck is ready. Cold weather slows the factory sealant, so shingles laid in winter may need hand sealing. Plan around a dry stretch, since the deck should never be covered while wet.
Local help
Shingle Roof Installation Near Me
New shingle roofs in Weehawken go on everything from new houses and additions to reroofs of older homes. From Weehawken out to neighboring towns such as Union City, West New York, Hoboken and Secaucus, houses built decades ago tend to need ventilation and flashing upgrades when they get a new shingle roof, which is why the system under the shingles deserves as much attention as the color. If you are searching for a shingle roof installer near me, ask what goes under the shingles, not just which shingle goes on top.
For shingle roof installation in Weehawken, NJ or nearby towns like Union City, West New York, Hoboken and Secaucus, call (551) 373-3025 to reach a roofer who covers your street.
How the weather here affects roofs around Weehawken
Cold winters bring snow, ice and a long stretch of freezing nights. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, which is how ice dams form and back water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. Most homeowners in Weehawken, NJ have the roof checked in the fall and again after the snow melts.
Why call
Why act early
Smaller repairs
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Local knowledge
Roofers in Weehawken know the roof types and weather wear common in local homes.
Clear next steps
Ask the roofer about the cause, the options and the estimate before work starts.
Common questions about shingle roof installation
Which is better, 3-tab or architectural shingles?
A 3-tab shingle is thin and uniform, and an architectural shingle is thicker, heavier and layered. The thicker build gives architectural shingles better wind resistance and a longer life, and many lines no longer offer 3-tab. 3-tab still works for sheds, garages or matching an existing roof.
What is the best season for a shingle roof installation?
Warm, dry days give the best results for a shingle install. Cold-weather installs are done regularly, with extra care for brittle shingles and hand sealing where the strips will not activate. Rain and snow are the real limits, since a wet deck should never be covered.
What goes under the shingles on a new roof?
The layers beneath shingles are drip edge, ice barrier, underlayment and starter strip, in that general order. Most roofers now use synthetic underlayment instead of felt, since it lies flat and resists tearing. The shingle instructions and local code set the minimum.
Why does nail placement matter on a shingle roof?
Nailing is what holds shingles down until the sealant bonds and long after. Most shingles take four nails, or six in high-wind zones. High or overdriven nails are a leading cause of blow-offs on newer roofs.
How steep does a roof need to be for shingles?
Shingles are made for slopes of 2 in 12 and steeper. Between 2 in 12 and 4 in 12, a double layer of underlayment or a full ice barrier is required to make up for slow runoff. Anything flatter needs a membrane roof such as TPO, EPDM or modified bitumen.
More questions? Call (551) 373-3025
Related services
Shingle Roof Replacement
Full shingle roof replacement, from tear-off and deck repair to new shingles and flashing, with soft decking fixed before anything new goes on.
Learn moreRoof Installation
Installing a new roof layer by layer, from drip edge and underlayment to flashing, vents and the finished roofing, with ventilation and flashing planned in from the start.
Learn moreRoof Ventilation
Roof ventilation work that keeps the attic dry in winter and cooler in summer, without mixing vent types that work against each other.
Learn moreGutter Installation
New gutters and downspouts formed to fit the house, with the right size, pitch and outlet placement, from K-style aluminum to half-round and copper.
Learn more
Looking for something else?
See all roofing servicesGet shingle roof installation help in Weehawken
Call now for Weehawken shingle roof installation and help in the towns around it.