New trim
New trim and boots at walls and penetrations instead of reusing old pieces.
Metal Roofing
Metal Roof Replacement Weehawken, NJ
When an old metal roof in Weehawken leaks in too many places to chase, replacement with new panels usually makes more sense than another round of screws and sealant, after checking the framing and decking underneath. Dial (551) 373-3025 to talk with a local roofer about replacing the roof.
Replacement comes up once rust or wear has spread past what patches and new fasteners can fix. When panels are perforated by rust, the finish is gone and every screw hole has been enlarged by years of movement, repairs stop keeping up. Older galvanized roofs with little coating left are the common candidates.
There are a few ways to replace a metal roof, and the right one depends on what is underneath. Tearing off lets the roofer see rotten purlins, soft decking and rusted fasteners before anything new is installed. A re-cover, or retrofit, installs new metal over the old panels on new sub-framing, which is common on shops and large buildings.
Many metal roof replacements are actually shingle roofs getting metal for the first time. The shingles can come off or, if local code permits and the deck is sound, the metal can go over them. It helps to know what is on the roof now, how old it is and whether it has ever been covered over.
If the problem goes deeper than it first looked, a Weehawken roofer may also recommend metal roof installation or metal roof repair.
Looking for Weehawken metal roof replacement? Call (551) 373-3025 to talk to a local roofer.
Call nowThe process
How metal roof replacement works
A metal roof replacement is planned around what is under the old roof.
Inspect the structure
A full look at the panels, framing and attic shows whether the roof can be re-covered or must come off. This decides tear-off, re-cover or partial panel replacement.
Pick the system
Tear-off, re-cover or metal over shingles is chosen, along with the new panel system, gauge and finish. The new panels are ordered cut to length.
Tear off
Old panels, trim and fasteners are removed and sorted for scrap metal recycling. Only as much roof is opened as can be covered the same workday.
Fix the purlins
Framing and sheathing damaged by old leaks are replaced before new metal goes on. New screws in rotten wood would fail within a few seasons.
Put on the new roof
High-temperature underlayment, new trim, panels, closures and flashing go on in order from the eaves up. Every edge gets new matching trim.
What is included
Parts of a metal reroof
Tear-off
Old metal panels, trim and fasteners are removed and taken for recycling.
New panels
The new metal system is fastened to the manufacturer pattern.
Re-cover option
Where suitable, new metal goes over the old roof on sub-framing with fasteners driven into the structure below.
Deck repair
Damaged structure is repaired so fasteners hold.
Related service
Metal Roof Panel Replacement Weehawken, NJ
When only a few panels are rusted through or torn, metal roof panel replacement can keep the rest of the roof in service. On exposed fastener roofs, the roofer removes the screws on the damaged panel and the overlapping edges of its neighbors, slides it out and sets a new one in sealant. Standing seam panels can be replaced too, but it takes more work to unseam and reseam the neighbors.
For a Weehawken building with one or two bad panels, panel replacement is often the sensible step. Expect a slight color difference between new and old metal. Too many swaps, and a full reroof is the smarter route.
Related service
Metal Roof Over Shingles Weehawken, NJ
Putting a metal roof over shingles means installing new metal on top of one existing layer of asphalt shingles instead of tearing them off. Battens or a new underlayment layer go over the shingles, then the metal is fastened into the decking below.
The tradeoff is that nobody sees the deck. For Weehawken homes, the attic check is critical, since rotted decking will not hold fasteners. If the deck is questionable or there are already two layers, a tear-off is the better choice.
Local help
Metal Roof Replacement Near Me
Around Weehawken, metal reroofs range from rusted farm buildings to houses getting their first standing seam roof. From Weehawken out to neighboring towns such as Union City, West New York, Hoboken and Secaucus, older metal roofs tend to need full replacement once the coating is gone, and newer houses are adding metal as their shingle roofs wear out, so it pays to have the framing checked before deciding on a re-cover.
For metal roof replacement in Weehawken, NJ or nearby towns like Union City, West New York, Hoboken and Secaucus, call (551) 373-3025 to reach a roofer who covers your street.
How the weather here affects roofs around Weehawken
Cold winters bring snow, ice and a long stretch of freezing nights. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Weehawken is busiest after a hard winter and before the next one.
Why call
Why act early
Smaller repairs
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Familiar with local homes
Local roofers see the same roofs and storm damage across Weehawken and nearby towns.
Straight answers
Ask your questions before you agree to anything.
Common questions about metal roof replacement
Is it a good idea to put metal over shingles?
Local code decides whether metal can go over existing shingles. The upside is skipping tear-off, while the downside is not seeing the decking. If the deck is questionable or there are two layers already, a tear-off is the better route.
What happens to the old metal roofing?
Removed metal panels are generally recycled. The old panels and trim are separated and sent to a recycler. Ask the roofer how disposal is handled before work starts.
When does a metal roof need replacing instead of repair?
The tipping point comes when rust or wear is spread across the roof, not just in a few spots. Widespread rust-through, failed paint and stripped holes everywhere usually mean new metal. A roofer can tell you which sections can be saved after a look at the roof and the framing.
Can I replace just one damaged metal panel?
One panel can usually be swapped without redoing the roof. The roofer unscrews the panel and its laps, removes it and fastens a matching one in place. Standing seam panels take more work because the seams must be opened.
What is a metal roof retrofit?
In a retrofit, new panels go over the old roof on spacers or purlins. It avoids tear-off and keeps the building closed during work, which is why it is common on shops, barns and commercial buildings. The framing must be sound enough to support both layers.
More questions? Call (551) 373-3025
Other services that may help
Metal Roof Installation
Metal roof installation built around the right panel, finish and trim for the house, for homes, garages and outbuildings.
Learn moreMetal Roof Repair
Replacing worn screws and washers, resealing panel laps, treating rust and fixing loose trim on metal roofs, without replacing panels that are still sound.
Learn moreRoof Replacement
Full tear-off and replacement for roofs that are worn out, storm beaten or leaking in several places, built to current code from the decking out.
Learn moreStanding Seam Metal Roof
Standing seam metal roofs with concealed clips, raised seams and no exposed screws in the panels, built to let the metal move without leaking.
Learn more
Looking for something else?
See all roofing servicesTalk to a Weehawken roofer about metal roof replacement
Call now for Weehawken metal roof replacement and help in the towns around it.